Apply Images Using DISM

Applies To: Windows 8, Windows 8.1, Windows Server 2008 R2, Windows Server 2012, Windows Server 2012 R2

This topic describes how to deploy images captured from your reference computer to one or more destination computers using the Deployment Image Servicing and Management (DISM) tool. For more information about configuring recommended hard drive partitions, see Configure UEFI/GPT-Based Hard Drive Partitions and Configure BIOS/MBR-Based Hard Drive Partitions.

Apply a Windows Image

On the destination computer, you will create a structure for the partitions where you apply your images. The partition structure on the destination computer must match the partition structure of the reference computer.

If you apply an image to a volume with an existing Windows installation, files from the previous installation may not be deleted. Format the volume by using a tool such as DiskPart before applying the new image.

To partition the hard drive and apply an image

1. Boot the destination computer to Windows PE. For more information, see WinPE for Windows 8: Windows PE 5.0.

2. Connect to the network distribution share where your Windows image is stored. For example, you can use the net use command to do this:

   net use n: \\server\share
   

   If prompted, provide your network credentials.

3. At the Windows PE command prompt, type diskpart to start the Diskpart tool.

4. Create your partition structure using the Diskpart tool. For example:

   select disk 0
   
   clean
   
   create partition primary size=3000 id=27
   
   format quick fs=ntfs label="Recovery"
   
   assign letter="R"
   
   create partition primary size=300
   
   format quick fs=ntfs label="System"
   
   assign letter="S"
   
   active
   
   create partition primary
   
   format quick fs=ntfs label="Windows"
   
   assign letter="C"
   
   exit
   

   This example temporarily assigns these drive letters: Windows=C, System=S, and Recovery=R. If you’re deploying to PCs with unformatted hard drives, change the Windows drive letter to a letter that’s near the end of the alphabet, such as W, to avoid drive letter conflicts. Do not use X, because this drive letter is reserved for Windows PE. After the PC reboots, the Windows partition is assigned the letter C, and the other partitions don’t receive drive letters.

   For examples of recommended partition structures, see Configure BIOS/MBR-Based Hard Drive Partitions and Configure UEFI/GPT-Based Hard Drive Partitions.

5. Use the DISM tool to apply images to your Windows partition.

   For each partition that you apply an image to, run the DISM/Apply-Image /ImageFile:<image_file> /index<index_number> /ApplyDir:<image_path> command.

   Dism /apply-image /imagefile:N:\Images\my-windows-partition.wim /index:1 /ApplyDir:C:\
   

   For more information about DISM, see DISM Image Management Command-Line Options.

6. To set up a basic system partition, you can use the BCDboot tool to copy a simple set of system files to a system partition. These files include boot configuration data (BCD) information that is used to start Windows:

   Use the BCDboot tool to copy common system partition files and to initialize boot configuration data:

   C:\Windows\System32\bcdboot C:\Windows /l en-US
   

   For more information about the BCDboot tool, see BCDboot Command-Line Options.