Randomly got bad pool caller and when I checked event viewer it had the following

SEANY boy 0 Reputation points
2025-11-04T14:58:46.7166667+00:00

As the title says I randomly got while I was using the pc bad pool caller (0xC2) then I looked at my event viewer and it said this

The computer has rebooted from a bugcheck. The bugcheck was: 0x000000c2 (0x000000000000000d, 0xffffc28417e7e7a0, 0x00000000506d7054, 0x000000005f636586). A dump was saved in: C:\WINDOWS\Minidump\110525-11828-01.dmp. Report Id: 72d5b86d-d421-4bee-9b88-bd0b20cf2865.

I have seen some other users say to use v2 log collector so I got that and ran it I'll attach it also

https://www.dropbox.com/scl/fo/ixjm4e93otffkce0vis8e/AHVuITWwLssntR6Oxz1B0DA?rlkey=mnt9sdumq64zgjzlx6tbsdyvn&st=zsvtr8wd&dl=0

Thank you for your time.

Windows for home | Windows 11 | Performance and system failures
0 comments

1 answer

Sort by: Most helpful
Most helpful Newest Oldest
  1. DaveM121 799.1K Reputation points Independent Advisor
    2025-11-04T15:33:50.6833333+00:00

    There was only one minidump file in your upload and that just indicated generic errors, nothing specific as the cause of the system crashing.

    To try to force Windows to show any faulting drivers, the best option would be to turn on Driver Verifier, let your PC crash 3 times, then you must turn off Driver Verifier, and finally, upload any newly created minidump files

    Before you run Driver Verifier, please create a new System Restore Point

    https://video2.skills-academy.com/en-us/answers/questions/4377096/(article)-driver-verifier-tracking-down-a-mis-beha?forum=windows-windows_10-update&referrer=answers

    .

    .

    .

    Note, if you have any difficulty getting into Windows with Driver Verifier enabled:

    Start your PC, just as Windows attempts to load (spinning dots), press and hold Power Button for 5 - 10 seconds to perform a Hard Shut Down

    Do this twice

    On the third start Windows will boot into the Recovery Environment and from there you can access System Repair, Safe Mode, Command Prompt... etc.

    Go to Troubleshoot - Advanced Option - Startup Settings and click Restart

    Upon restart, press 4 to enter Safe Mode

    Open Command Prompt as Administrator and run these two commands, then restart your PC.

    verifier /reset

    verifier /bootmode resetonbootfail

Your answer

Answers can be marked as 'Accepted' by the question author and 'Recommended' by moderators, which helps users know the answer solved the author's problem.