Make sure the Logic App is configured as shown in the section "Set up Azure Monitor logs"
Azure Logic App : Logs not showing in Log Analytics workspace and AzureDiagnostics log table
I have been following the following article :
https://video2.skills-academy.com/en-gb/azure/logic-apps/monitor-logic-apps-log-analytics
But even after following all the steps in the article , I cant see any data in Logic Apps Management section of my Log Analytics workspace.
It is always showing 0 data.
By further analysis , I can see that there is no data in AzureDiagnostics table in my logs. There is data in rest 2 tables i.e. AzureActivity and AzureMetrics. Ideally when I have enabled the diagnostics, the table should have been populated.
3 answers
Sort by: Most helpful
-
-
MayankBargali-MSFT 70,421 Reputation points
2020-08-27T08:15:07.31+00:00 Can you click on preview data for AzureActivity and see if you are able to see any data?
Once the preview data window is opened please click on "See in query editor" and write the below query to check the last 1hr data after performing a test execution in logic app end.
AzureActivity
| where TimeGenerated > ago(24h)
| limit 10Also, can you confirm if you have selected "workflow runtime" and "all metrics" in the diagnostic setting configuration of your logic app.
I have tested the setup at my end following this article and didn't observe any issue.
-
Kailash Pandey 36 Reputation points
2020-10-18T23:44:07.743+00:00 Hi @Mulchandani, Jaideep & @MayankBargali-MSFT ,
I ran into the same issue and my Azure Logic App Management dashboard is always empty. And logics app are running every day and they have been configured exactly the same way as been described in the https://video2.skills-academy.com/en-gb/azure/logic-apps/monitor-logic-apps-log-analytics.@MayankBargali-MSFT -
under a specific logic app logs, if I run this query "AzureMetrics | where TimeGenerated > ago(24h) ", I get some results but as you asked to click on Preview Data under Azure Activity, I get an error saying "Error retrieving data". Please see the screenshot and any help will be appreciated