Remove-CaseHoldRule
This cmdlet is available only in Security & Compliance PowerShell. For more information, see Security & Compliance PowerShell.
Use the Remove-CaseHoldRule cmdlet to remove case hold rules from the Microsoft Purview compliance portal.
For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.
Syntax
Remove-CaseHoldRule
[-Identity] <PolicyIdParameter>
[-Confirm]
[-ForceDeletion]
[-WhatIf]
[<CommonParameters>] Description
Removing a case hold rule causes the release of all Exchange mailbox and SharePoint site case holds that are associated with the rule. Removing a case hold rule also causes the corresponding case hold policy to become invalid, so you should remove it by using the Remove-CaseHoldPolicy cmdlet.
To use this cmdlet in Security & Compliance PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft Purview compliance portal.
Examples
Example 1
Remove-CaseHoldRule -Identity "One Year Standard"This example removes the case hold rule named "One Year Standard".
Parameters
-Confirm
The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.
- Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax:
-Confirm:$false. - Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
| Type: | SwitchParameter |
| Aliases: | cf |
| Position: | Named |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |
-ForceDeletion
The ForceDeletion switch forces the removal of the rule. You don't need to specify a value with this switch.
| Type: | SwitchParameter |
| Position: | Named |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |
-Identity
The Identity parameter specifies the case hold rule to remove. You can use any value that uniquely identifies the rule. For example:
- Name
- Distinguished name (DN)
- GUID
| Type: | PolicyIdParameter |
| Position: | 1 |
| Default value: | None |
| Required: | True |
| Accept pipeline input: | True |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |
-WhatIf
The WhatIf switch doesn't work in Security & Compliance PowerShell.
| Type: | SwitchParameter |
| Aliases: | wi |
| Position: | Named |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |