Setting Up the Hitachi US7750 HARP (Aspen) SDB Hardware

  • Article

The following steps show you how to connect the Hitachi US7750 HARP (Aspen) SDB to a development workstation.

To set up the Hitachi US7750 HARP (Aspen) SDB hardware

  1. On the Hitachi US7750 HARP (Aspen) SDB, detach the Tahoe board.

  2. On the Hitachi US7750 HARP (Aspen) SDB, connect a 25-pin ribbon cable to the CN4 connector, so that pin 1 is near the Dbg Ser port.

    You can identify pin 1 by the red stripe on the 25-pin ribbon cable.

  3. On the Hitachi US7750 HARP (Aspen) SDB, attach the power supply and reattach the Tahoe board.

  4. If you are using the MQ200 display card, be sure that switch S1 on the MQ200 is set to the Down position, otherwise the MQ200 will not function correctly.

  5. On the development workstation, connect a serial port to the Hitachi US7750 HARP (Aspen) SDB debug serial port, and then set the baud rate to 57600.

    The debug serial port is located on the front panel and is labeled Dbg Ser.

See Also

How to Use the BSP for the Hitachi US7750 HARP (Aspen) SDB

Last updated on Wednesday, April 13, 2005

© 2005 Microsoft Corporation. All rights reserved.