EVT_WDF_DEVICE_D0_EXIT callback function (wdfdevice.h)

[Applies to KMDF and UMDF]

A driver's EvtDeviceD0Exit event callback function performs operations that are needed when the driver's device leaves the D0 power state.

Syntax

EVT_WDF_DEVICE_D0_EXIT EvtWdfDeviceD0Exit;

NTSTATUS EvtWdfDeviceD0Exit(
  [in] WDFDEVICE Device,
  [in] WDF_POWER_DEVICE_STATE TargetState
)
{...}

Parameters

[in] Device

A handle to a framework device object.

[in] TargetState

A WDF_POWER_DEVICE_STATE-typed enumerator that identifies the device power state that the device is about to enter.

Return value

If the EvtDeviceD0Exit callback function encounters no errors, it must return STATUS_SUCCESS or another status value for which NT_SUCCESS(status) equals TRUE. Otherwise, it must return a status value for which NT_SUCCESS(status) equals FALSE.

Remarks

To register an EvtDeviceD0Exit callback function, a driver must call WdfDeviceInitSetPnpPowerEventCallbacks.

If the driver has registered an EvtDeviceD0Exit callback function, the framework calls the function each time one of the driver's devices leaves its working (D0) state. A device leaves the D0 state when one of the following occurs:

• The system and all of its devices are about to leave their working states and enter a low-power state.
• The device is about to enter a low-power state because it is idle, if the device supports low-power idle.
• The Plug and Play manager is attempting to redistribute the system's hardware resources.
• A user has indicated, typically by means of an application's user interface, that he or she wants to remove the device.

For more information about when the framework calls this callback function, see PnP and Power Management Scenarios.

Unless the device has been surprise-removed, the framework calls this callback function immediately after it disables the device's interrupts, but before the device's power is reduced from D0. The TargetState parameter identifies the device power state that the device is about to enter.

The EvtDeviceD0Exit callback function must perform any operations that are necessary before the device enters the specified low-power state, such as saving any information that the driver will need later to restore the device to its D0 power state.

If the TargetState parameter is WdfPowerDevicePrepareForHibernation, the driver must not shut off the device, because the system will use the device when saving its hibernation file.

If TargetState is WdfPowerDeviceD3Final, you should assume that the system is being turned off, the device is about to be removed, or a resource rebalance is in progress. If your driver must save information, it should write it to disk or some other permanent storage medium. However, it is incorrect to check WdfPowerDeviceD3Final and then do cleanup work for device removal. For example, if a device that has entered Dx power state because of idling out is then later surprise removed, its EvtDeviceD0Exit won't be called again. The correct place to do this work would be in EvtDeviceReleaseHardware instead.

For more information about drivers that provide this callback function, see Supporting PnP and Power Management in Function Drivers.

Requirements

See also

EvtDeviceD0Entry