DrvLineTo function (winddi.h)

The DrvLineTo function draws a single, solid, integer-only cosmetic line.

Syntax

BOOL DrvLineTo(
  SURFOBJ  *pso,
  CLIPOBJ  *pco,
  BRUSHOBJ *pbo,
  LONG     x1,
  LONG     y1,
  LONG     x2,
  LONG     y2,
  RECTL    *prclBounds,
  MIX      mix
);

Parameters

pso

Pointer to a SURFOBJ structure that describes the surface on which to draw.

pco

Pointer to a CLIPOBJ structure that defines the clip region in which the rendering must be done. No pixels can be affected outside this clip region.

pbo

Pointer to a BRUSHOBJ structure that specifies the brush to use when drawing the line.

x1

Specify the integer x-coordinates of the line's beginning point.

y1

Specify the integer y-coordinates of the line's beginning point.

x2

Specify the integer x-coordinates of the line's end point.

y2

Specify the integer y-coordinates of the line's end point.

prclBounds

Pointer to the RECTL structure that defines the integer rectangle that bounds the unclipped line. Drivers that support hardware line drawing can use this rectangle to quickly determine whether the line fits in a coordinate space small enough to be rendered by the hardware.

mix

The mix mode that defines the foreground and background raster operations to use for the brush. In the call to DrvLineTo, the foreground and background raster-operation values are the same. For more information about mix mode, see Remarks.

Return value

DrvLineTo returns TRUE if it succeeds; otherwise, it returns FALSE.

Remarks

DrvLineTo is an optional entry point that a driver can supply as an optimization for application calls to the Win32 LineTo function. If the driver doesn't hook DrvLineTo, or if the driver returns FALSE from a call to this function, GDI will automatically call DrvStrokePath instead. A driver that has hooked DrvLineTo can call EngLineTo when the rendering surface is a DIB.

This function is simpler than DrvStrokePath because it supports only integer end-points and solid cosmetic lines. GDI has less overhead when calling DrvLineTo instead of DrvStrokePath; consequently, DrvLineTo is intended to be used as a simple optimization by drivers that can accelerate nominal width lines in hardware.

The mix mode defines how the incoming pattern should be mixed with the data that is already on the device surface. The MIX data type consists of two binary raster operation (ROP2) values packed into a single ULONG. The lowest-order byte defines the foreground raster operation; the next byte defines the background raster operation. For more information about raster operation codes, see the Microsoft Windows SDK documentation.

Requirements

See also

BRUSHOBJ

CLIPOBJ

DrvStrokePath

EngLineTo

SURFOBJ