Intel 815-based SDB (Windows CE 5.0)

Send Feedback

In general, the only changes you need to make in the BIOS are in the PnP and PCI Settings menu. You can choose the defaults for all other settings.

Asus TUSL2-C Intel 815EP SDB CMOS Setup

The following table shows the standard CMOS setup for the Asus TUSL2-C Intel 815EP SDB.

Setting Description
Date Your local date
Time Your local time
Primary Master Auto

Supports the ATAPI CD-ROM drive that must be the primary master.

Primary Slave None

A hard drive can be installed on a CEPC and boot to other operating systems, or it can be used to load images.

Secondary Master None
Secondary Slave None
Drive A 1.44 and 3.5 inch
Drive B None
Floppy 3 Mode Support Disabled
Video EGA/VGA
Halt On No errors

Asus TUSL2-C Intel 815EP SDB BIOS Setup

The following table shows the BIOS setup.

Setting Description
Boot Virus Detection Disabled
Processor Serial Number Not applicable
CPU Level 1 Cache Enabled
CPU Level 2 Cache Enabled
CPU Level 2 Cache ECC Check Disabled
BIOS Update Enabled
Quick Power On Self Test Enabled
HDD Sequence SCSI/IDE First IDE
Boot Sequence A, CDROM, C

It is possible to create bootable CD-ROMs and load Nk.bin from the CD-ROM

Boot Up Floppy Seek Disabled
Floppy Disk Access Control R/W
IDE HDD Block Mode Sectors HDD MAX
HDD S.M.A.R.T. Capability Disabled
PS/2 Mouse Function Control Auto
OS/2 Onboard Memory > 64M Disabled
PCI/VGA Palette Snoop Disabled
Video ROM BIOS Shadow Enabled
C8000-CBFFF Disabled
CC000-CFFFF Disabled
D0000-D3FFF Disabled
D4000-D7FFF Disabled
D8000-DBFFF Disabled
DC000-DFFFF Disabled
Boot Up NumLock Status On
Typematic Rate Setting Disabled
Typematic Rate (Chars/Sec) 6
Typematic Delay (Msec) 250
Security Option System

Asus TUSL2-C Intel 815EP SDB Chipset Setup

The following table shows the chipset setup for the Asus TUSL2-C Intel 815EP SDB.

Setting Description
SDRAM Configuration By SPD
CDRAM CAS Latency By SPD
SDRAM RAS to CAS Delay By SPD
SDRAM RAS Prechard Time By SPD
DRAM Idle Timer 8T
DRAM MA Wait State Normal
Snoop Ahead Enabled
Host Bus Fast Data Ready Disabled
16-bit I/O Recovery Time 1 BUSCLK
8-bit I/O Recovery Time 1 BUSCLK
Graphics Aperture Size 64MB
Video Memory Cache Mode UC
PCI 2.1 Support Enabled
Memory Hole at 15M-16M Disabled
Onboard FDC Controller Enabled
Onboard FDC Swap A&B No Swap
Onboard Serial Port 1 3F8H/IRQ4
Onboard Serial Port 2 2F8H/IRQ3
Onboard Parallel Port 378H/IRQ7
Parallel Port Mode ECP+EPP
ECP DMA Select 3
UART2 Use Infrared Disabled
Onboard PCI IDE Enable Primary. This disables the secondary IDE channel.
IDE Ultra DMA Mode Auto
IDE0 Master PIO/DMA Mode Auto
IDE0 Slave PIO/DMA Mode Auto
IDE1 Master PIO/DMA Mode Auto
IDE1 Slate PIO/DMA Mode Auto

Asus TUSL2-C Intel 815EP SDB Power Management Setup

The following table shows the power management setup for the Asus TUSL2-C Intel 815EP SDB.

Setting Description
Power Management User Defined
Video Off Option Suspend->Off
Video Off Method DPMS Off
HDD Power Down Disabled
Suspend Mode Disabled
PWR Button < 4 seconds Soft Off
PNP OS Installed No. This is required.
Slot 1 IRQ If IRQ = 0 and IoBase = 0 in AutoExec.bat on the boot disk, the boot loader searches for the Ethernet Debug Card.
Slot 2 IRQ Auto
Slot 3 IRQ Auto
Slot 4 IRQ Auto
PCI Latency Timer 0 PCI Clock
IRQ 3 Used by ISA No/ICU
IRQ 4 Used by ISA No/ICU
IRQ 5 Used by ISA Yes. This is for the ISA NE2000 NIC. IRQ 5 and base address 340h are used; however, you can use a different IRQ and base address if you modify the call to LoadCEPC.exe on your boot disk.
IRQ 7 Used by ISA No/ICU
IRQ 9 Used by ISA No/ICU
IRQ 10 Used by ISA No/ICU
IRQ 11 Used by ISA Yes, this IRQ is used by the ISA-based PCMCIA reader.
IRQ 12 Used by ISA No/ICU
IRQ 14 Used by ISA No/ICU
IRQ 15 Used by ISA No/ICU
DMA 1 Used by ISA No/ICU
DMA 3 Used by ISA No/ICU
DMA 5 Used by ISA No/ICU
ISA MEM Block BASE No/ICU
SYMBIOS SCSI BIOS Auto
USB IRQ Enabled
VGA BIOS PCI/AGP
Sequence Enabled
PWR Up On Modem Act Disabled
AC PWR Loss Restart Disabled
Power Up By Keyboard Disabled
Wake On LAN Disabled
Automatic Power Up Disabled

See Also

CEPC-based SDBs | How-to Topics

Send Feedback on this topic to the authors

Feedback FAQs

© 2006 Microsoft Corporation. All rights reserved.