XPS_SEGMENT_TYPE enumeration

Describes a line segment.

Syntax

typedef enum  { 
  XPS_SEGMENT_TYPE_ARC_LARGE_CLOCKWISE         = 1,
  XPS_SEGMENT_TYPE_ARC_LARGE_COUNTERCLOCKWISE,
  XPS_SEGMENT_TYPE_ARC_SMALL_CLOCKWISE,
  XPS_SEGMENT_TYPE_ARC_SMALL_COUNTERCLOCKWISE,
  XPS_SEGMENT_TYPE_BEZIER,
  XPS_SEGMENT_TYPE_LINE,
  XPS_SEGMENT_TYPE_QUADRATIC_BEZIER
} XPS_SEGMENT_TYPE;

Constants

• XPS_SEGMENT_TYPE_ARC_LARGE_CLOCKWISE
  The line segment is an arc that covers more than 180 degrees and is drawn in a clockwise direction from the start point to the end point.

• XPS_SEGMENT_TYPE_ARC_LARGE_COUNTERCLOCKWISE
  The line segment is an arc that covers more than 180 degrees and is drawn in a counterclockwise direction from the start point to the end point.

• XPS_SEGMENT_TYPE_ARC_SMALL_CLOCKWISE
  The line segment is an arc that covers at most 180 degrees and is drawn in a clockwise direction from the start point to the end point.

• XPS_SEGMENT_TYPE_ARC_SMALL_COUNTERCLOCKWISE
  The line segment is an arc that covers at most 180 degrees and is drawn in a counterclockwise direction from the start point to the end point.

• XPS_SEGMENT_TYPE_BEZIER
  The line segment is a cubic Bezier curve that is drawn between two points.

• XPS_SEGMENT_TYPE_LINE
  The line segment is a straight line that is drawn between two points.

• XPS_SEGMENT_TYPE_QUADRATIC_BEZIER
  The line segment is a quadratic Bezier curve that is drawn between two points.

Remarks

A geometry segment is described by the start point, the segment type, and additional parameters whose values are determined by the segment type. The coordinates for the start point of the first segment are a property of the geometry figure. The start point of each subsequent segment is the end point of the preceding segment.

The table that follows shows an example of each segment type.

Requirements

See also

XML Paper Specification