EWF Configuration in Target Designer
5/10/2007
Using the EWF Configuration Settings window of the Target Designer to configure EWF as a Windows XP Embedded component during the offline design phase For example:
.gif "Bb521570.1e58ab48-c61a-45db-bb4f-b64bc955a1b8(en-US,WinEmbedded.5).gif")
The following table explains the items shown in the EWF Configuration Settings window:
Number of Protected Volumes |
Sets the number of volumes EWF will protect. Range: 1-9 |
Maximum Number of Overlay Levels |
Sets the maximum overlay level for DISK overlays. Range: 1-9. (Always 1 for RAM overlays.) |
EWF Partition Size in KBytes |
Sets the size of the EWF partition. Defaults to 1024 for DISK overlays, value is N/A for RAM overlays. |
Disable Background Disk Defragmentation |
Yes/no checkbox |
Enable HORM |
Yes/no checkbox |
Protected Volume Prev/Next Buttons |
Moves to individual settings for each protected volume (governed by # volumes option above) |
Start EWF Enabled |
Yes/no checkbox (per volume) |
Enable Lazy Write |
Yes/no checkbox (per volume – enables "Lazy write" mode) |
Disk Number |
Specifies disk(x) value in arc path for this volume |
Partition Number |
Specifies partition(x) value in arc path for this volume |
Overlay Type |
Select between DISK, RAM and RAM (Reg) modes for this volume |
Optimization |
Option Select options to optimize EWF performance |